So I finally got power into the mini shop. No more extension cables running around.
On the opposite side into the master there was an outlet I was able to tap into for the Mini Shop desk. To get power to the half rack that the 3D Printers the opposite side of that wall is the Dining room and there was an outlet I tapped into.
The house has D-Square X-Series outlets and switches so I ordered the same type for these additional outlets. The Dining room uses 12 gauge wire on a 20amp breaker. The master uses 14 gauge on a 15amp breaker. Either way I’m covered.
Now I can start 3D Printing hangers and such for my equipment for the Mini shop.
The Garage will be next. I need to paint the ceiling and walls first then I can install two ceiling fans and some additional outlets. Also since the HOA here wants the garbage cans not in view I decided to see about a garage door opener. Since I am doing a IQ4 Qolsys panel I know Aladdin Connect works well with the Alarm.com integration. So I am looking at this opener from Genie. I think it’s the same model a couple of home builders I work with uses.