Brought in the base and started mounting hardware to it.
Since I use to repair Arcade machines I had some hardware left over for mounting the Motherboard and control board. These standoffs are easy to install. Use a punch to mark the screw hole locations then sit the standoff over that punched hole and drive a screw in.
The GPU bracket is 3D Printed in PLA+ at 50% infill.
The SSD had a blue sticker on it so I used some green vinyl car wrap to cover it up.
Here is an idea on how the finished product will look like. I still need to cut some more holes and route the cabling.
Waiting on the green LED strips to come in. Planning to put them under the Motherboard, control panel and inside the power supply. I might just buy a LED lit fan. I was eyeballing this one.
The more I work on this the more my PC modding days are coming back to haunt me lol.